Shandong Weite Transformer Factory
Call us on:+86-536-3863999   E-mail:
Home > News > Content
30kv 33kv 35kv High Voltage Oil Immersed Power Transformers
Shandong Weite Transformer Factory | Updated: May 19, 2017

30kv 33kv 35kv High Voltage Oil Immersed Power Transformers

30kv 33kv 35kv High Voltage Oil Immersed Power Transformers.jpg

Compared with common oil-immersed transformer, it is unnecessary for full-sealed transformer to be equipped with oil conservator and change in oil volume is automatically adjusted and compensated by elasticity of corrugated sheet of corrugated tank, and transformer is isolated from air to prevent and slow down oil degrading and insulation aging, enhance operational reliability,with normal operation and no maintenance.

Product feature:

1. The transformer core is stacked by imported high-quality cold-rolled silicon steel sheet, which reduces no-load loss and no-load current greatly, and makes the core bound to ensure compactness of the core
and reduce noise.
2. High-low voltage winding is wound with oxygen-free cooper, low-voltage winding of 500kVA and below
adopts double layer cylinder structure, that of 630kVA and above adopts double helix and four helix structure,and high-voltage winding adopts multilayer cylinder structure.
3. Transformer winding connection adopts Dyn11 to reduce influences of harmonic wave on the power grid and improve power supply quality.
4. The transformer is of full-sealed structure to prolong the shelf life and avoid suspended core use and
5. The measured noise level is below the standard.No suspended-core inspection is needed for this series of transformer after normal transportation and relevant unloading parts can be installed immediately, test for acceptance items shall be performed and it can be put into operation after passing the test.

Service conditions:

1. Maximum ambient temperature: +40°C
2. Minimum ambient temperature: -25°C
3. Altitude: <1000m
4. Maximum monthly average relative humidity: 90%(20°C)
5. Installation site: installed on sites without fire,explosion hazard, serious pollution, chemical corrosion
or violent vibration, indoor or outdoor.

Normal S11-M Series Transformer apply to the altitude below 1000m; the circumstance temperature between -25oC and +40oC.
Technical parameters:
1. Rated capacity: 20~2500kVA
2. Rated HV: 10~15 kV
3. Rated LV: 0.4kv
4. Frequency: 50Hz or 60Hz
5. Cooling methods: ONAN/ONAF
6. Tapping Range: ±5%   ±2x2.5%  
7. Phase: Single Phase or Three Phases
8. Connection Symbol: Yyn0 or Dyn11

Product Categories

Fast Track

Copyright © Shandong Weite Transformer Factory